"Labview program to read volatge input using PCI-6013 card"

[Jalan]

I have recently bought NI PCI-6013 Basic Multifunction I/0 Board,
BNC-2120 Accessory for 68 Pin and 100 Pin E Series Devices and
SH68-68-EP, Shielded Cable.I have connected the photo-diode output to
the BNC-2120 channel 2 which is connected to the PCI-6013 card. I
think the connections and card installation is perfect as mesurement
and automation explorer in labview identifies the pCI-6013 and the
test panel run without any error. My aim is to write a Labview program
to read the average voltage of the analog input in the pci-card. Can
someone send me a example or the procedure to do it ?

[ian.f]

In the LabVIEW Dialog:
Search Examples > I/O Interfaces > Data Acquisition (DAQ)

You should be able to get some idea through examples found in the
above location.

[Jalan]

I am not able to find the examples.

Jalan

[ian.f]

now... open a new vi.
From the Help Menu, look for Examples...

[Jalan]

Ya I have looked on that I did find IO there. But then the examples
given in that doesnot find it uselful for me. I also checked in
DAQ-STC. But its agian not useful.

[ian.f]

Most of the examples (provided by NI-LabVIEW) are of useful, and I
believe so. What I mean is that these examples are there to give user
some ideas on how DAQ (for your case) works, thus it may not be
exactly what you are looking for.

Others might be able to provide you with some examples.
Alternatively, you might wanna consider approach your local NI office
for help.

Good luck